Maximum power. Maximum reliability.
Look Keo 2 Max Carbon pedal increases efficiency and comfort. It’s light. It’s
RESISTANT CLEAT CONTACT AREA
- For a more efficient and more comfortable pedal stroke, the Kéo 2 MAX has a
cleat contact surface area 12% larger than the Kéo Carbon. To further improve
the transfer of power and to longevity of the pedal, this surface area is made
of stainless steel molded directly into the pedal body.
122gr - At a mere 122 grams (in Carbon Version, 130g in Composite), the Kéo 2
MAX is one of the lightest pedals in its category. This has been achieved
through the use of a carbon injection process allowing for weight reduction and
- Particular attention was focused on reliability and provided through features
such as: a carbon injected pedal body, a stainless steel cleat contact area, an
oversized axle with dual seals, making this a pedal built to last. The new line
of Kéo 2 MAX pedals maintains a low cleat contact height even with the use of a
steel oversize axle. The pedal is built with two miniature ball bearings (12mm
inner x 18mm outer diameters) and a needle roller bearing. Look axles are only
approved once they have survived a million cycles at 100 revolutions per minute
with a 90kg (198lbs) load at the center of the pedal and an eccentric rotation
(replicating a bump each revolution). This test largely surpasses current
standards (reference NF EN 14781). Dual seals increase bearing longevity.
Q-FACTOR - Thanks
to 14mm of threads on the new Look axle, the Q-factor may be extended by 2mm
with the use of specific washers available separately. Use of these specific
washers results in a Q-factor of 55mm versus the original 53mm.